Date of issue: 2021/4/28 2:26:22 Hits: 1288
The hydraulic cylinder is the heart of the hydraulic system, so the maintenance of the hydraulic cylinder is the most important part of the maintenance of the entire hydraulic system. It is difficult to repair the heart problem, so the maintenance of the hydraulic cylinder must be very rigorous and meticulous. The following section will introduce the application, protection and protection methods of the hydraulic cylinder. Let's have a look.
Application protection and protection method of hydraulic cylinder
1、 Application and protection of hydraulic cylinder
1. The viscosity of oil used for hydraulic cylinder is 29~74mm2/S. ISO VG46 anti-wear hydraulic oil is recommended.
2. The filtering accuracy of hydraulic cylinder request system shall not be lower than 80um request, and oil pollution shall be strictly controlled.
3. During assembly, it shall be ensured that the deviation of the front end of the piston rod shall be the same as that of the cylinder head and earings, and the straightness of the piston rod in the process of advancing and retreating.
4. Before disassembling, loosen the overflow valve to make the pressure of the hydraulic circuit drop to zero, then cut off the power supply to stop the hydraulic assembly, and after loosening the oil port piping, plug the oil port with an oil plug.
Application protection and protection method of hydraulic cylinde
2,、 Protection method of hydraulic cylinder
1. Rust prevention
Because the piston part of the hydraulic oil cylinder will stretch out of the oil cylinder in the working state, it will naturally be corroded by oxides and acid gases, which requires us to coat it with appropriate grease for protection, so as to prevent the piston, as a load-bearing component, from being corroded and may break during the work.
2. Open the box and change the oil
The cylinder is sealed with vaporizing rust inhibitor, so the inlet plug shall not be removed before assembly. After the plug is removed, it should be installed on the engine body immediately, and the oil cylinder should be filled with oil. In order to prevent foreign matters from entering the hydraulic cylinder and increasing friction, the oil should also be changed frequently. The hydraulic oil also has a certain service life. If the oil is not changed for a long time, the internal part of the hydraulic cylinder will be damaged or eroded.
3. To control speed
During the operation of the hydraulic oil cylinder, the speed shall be controlled properly, and shall not exceed 2m/s, which can extend the service life of the hydraulic oil cylinder. The internal buffer device is useful for the protection of the hydraulic oil cylinder.
